Stone flour processing equipment may encounter various equipment problems during operation and processing. How to deal with them? Today, I'll analyze the problems often encountered by stone flour processing equipment and their solutions.

1.石磨面粉機機身晃動，應該擰緊磨頭和機架之間的聯接螺栓。

1. When the body of the stone flour mill shakes, the connecting bolts between the grinding head and the frame should be tightened.

2.產量下降，應調緊彈簧，以保證磨輥兩端的間隙一致，對產生磨損的磨齒進行及時的修理。

2. When the output decreases, the spring shall be tightened to ensure that the clearance at both ends of the grinding roller is consistent, and the worn grinding teeth shall be repaired in time.

3.面粉溫度高，應調松磨輥;若磨輥磨損比較嚴重時就應進行修理或更換；機溫過高時就需進行停機散熱。

3. If the flour temperature is high, loosen the grinding roller; If the grinding roller is seriously worn, it shall be repaired or replaced; When the machine temperature is too high, it needs to be shut down for heat dissipation.

4.不出麩皮，原因可能是主軸的轉向不對，篩框的密封不嚴密或篩網出現破損。

4. No bran is produced, which may be due to the wrong rotation of the main shaft, the loose sealing of the screen frame or the damage of the screen.

5.不出粉或出粉少，原因為篩堵塞。

5. No or little powder is produced because the screen is blocked.

6.機械電壓過低，配電線缺線，線路接觸不良，控制回路斷線，保險絲熔斷等，導致無法啟動。

6. The mechanical voltage is too low, the distribution line is missing, the line contact is poor, the control circuit is broken, the fuse is blown, etc., resulting in failure to start.

石磨面粉機在使用時要時常給機器各零件加潤滑油，減少他們的磨損。

When the stone flour mill is in use, it is necessary to often add lubricating oil to all parts of the machine to reduce their wear and tear.